Muratec MFX-1300 Field Engineering Manual page 87

Unique Switch g:0 - Remote reception
Initial
Switch
Setting
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 Factory use only
3 1 Factory use only
2 0 Use numeric keypad on the
fax using second phone
(Only for MFX-1300/1200)
0: No
1: Yes
1 1 Manual transmit/receive
using Start key after off-hook
of second phone
(Only for MFX-1300/1200)
0: No
1: Yes
0 0 Silent detection
0: No
1: Yes
Unique Switch g:1
Unique Switch g:7 – Remote reception and TAD interface
Initial
Switch
Setting
7 0 Factory use only
6 0 Factory use only
5 0 Strict condition of CNG
detection after OGM output
0: No
1: Yes
4 0 CNG detection during OGM
output in ANS Ready
0: Yes
1: No
3 0 Number of detection DTMF
2 0
1 1
0 1
Adjust
Determines if using the numeric keypad on the
control panel of the fax using the second phone.
Determines if transmitting or receiving manually
using Start key after off-hook of the second phone.
Note: Initial setting for MFX-1700 is "0".
Enables or disables silent detection during Ans/Fax
Ready mode.
g:6 --- Factory use only
Adjust
When set at "1", the condition of CNG detection
becomes strict. CNG should be detected 2times
continuously and the OFF time should be 2 4 sec.
Sets the number of detection the DTMF during
Ans/Fax Ready mode.
Switch 3 2 1 0
3-57
Usage/Comments
Usage/Comments
Number of detection
0 0 0 0 Not detect
0 0 0 1 1
0 0 1 0 2
0 0 1 1 3 Initial setting
0 1 0 0 4
0 1 0 1 5
1 1 1 1 15