Attaching the OP-100 (and NP-200)
Note: Make sure to turn off the fax machine before proceeding the following steps.
1. Attach the BRACKET to the PRINTER CONTROL PCB using two screws.
Note: The bracket may have been attached to the PRINTER CONTROLLER PCB.
Note: The OP-100 can attach the DIMM on the board for memory upgrade.
The DIMM which have the following specifications can be attached:
• 144 pin JEDEC standard, 8byte Dual In-line Memory Module
• Synchronous DRAM S.O.DIMM.
• Single 3.3V power supply.
If you also attaching the NP-200, attach the BRACKET to the NIC PCB using two screws.
Note: The bracket may have been attached to the NIC PCB.
DIMM
6-13