Muratec MFX-1300 Field Engineering Manual page 68

Output attenuation when individual autodialer attributes are set.
Switch -15 -14 -13
dB dB dB
3 1 1
2 1 1
1 1 1
0 1 0
Initial setting for MFX-1700/1600
Attribute 3 - Individual Autodialer Setting
Initial
Switch
Setting
7 0 Data signaling rate (DCS)
0: V.17
1: V.33
6 0 Forced received print when
transmitting from memory
0: No
1: Yes
5 0 European date format on TTI
0: No
1: Yes
4 1 TTI transmit
0: No
1: Yes
3 0 ECM response time
0: 3 sec
1: 4.8 sec
2 0 ECM error retransmit time
0: 200 ms
1: 400 ms
1 0 Interval between DIS and DCS
0 0
Switch 1
Switch 0
-12 -11 -10 -9
dB dB dB dB
1 1 1 1 1
1 1 0 0 0
0 0 1 1 0
1 0 1 0 1
Adjust
0 ms 500 ms 1000 ms 1500 ms
0 0 1
0 1 0
-8 -7 -6 -5
dB dB dB dB
1 0 0 0
0 1 1 1
0 1 1 0
0 1 0 1
(Equivalent to Memory Switch B:2)
Usage/Comments
Determines communication protocol.
Will force a remote Muratec machine with memory
receive capabilities to print directly. This switch will
prevent a memory overflow error at the remote unit.
Assigns European date format to the transmitted
TTI.
(Example: 29 January 2001)
When set at "0", transmission of the TTI is disabled.
(Note: Turning TTI transmission off may violate
local or federal regulations.)
The time limit to receive the response signal for the
ECM post message.
The time limit before the ECM error is
retransmitted.
1
1
3-38
-4 -3 -2 -1 -0
dB dB dB dB dB
0 0 0 0 0
1 0 0 0 0
0 1 1 0 0
0 1 0 1 0
Initial setting for MFX-1300/1200