Muratec MFX-1300 Field Engineering Manual page 55

Memory Switch C:0 - Reception
Initial
Switch
Setting
7 0 Data error rate
0: 10%
1: 20%
6 0 Pause one second after
sending CED
0: No (75 ms)
1: Yes (1 sec)
5 0 Factory use only
4 0 Factory use only
3 0 Receive speed (kbps)
Maximum receive speed may be slowed to compensate for poor phone lines.
2 1 2.4 4.8 7.2 9.6 12 14.4 16.8 19.2 21.6 24 26.4 28.8 31.2 33.6
0
0
1 0 0
0
0 1
Initial setting for MFX-1300/1200
Note: The maximum speed for the MFX-1300/MFX-1200 is 14.4 kbps.
Memory Switch C:1 - Reception
Initial
Switch
Setting
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 T1 timer
0: 35 sec
1: 20 sec
3 1 Print image data when post
message is not received after
receiving RTC signal
0: No
1: Yes
2 0 Disable ITU-T superfine
reception
0: Yes
1: No
1 0 G3 echo receive
Adjusts the delay between detection of training/TCF and sending of CFR.
0 1
Switch 1
Switch 0
Memory Switch C:2
Adjust
0 0 0 0 0 0
0 0 0 1 1 1
0 1 1 0 0 1
1 0 1 0 1 0
Adjust
100 ms 500 ms 800 ms 1200 ms
0 0 1
0 1 0
C:9 --- Factory use only
Usage/Comments
Determines the allowable number of erred lines out
of total lines received in a document.
A 2100 Hz CED signal disables echo suppression in
some telephone equipment. When set to "1", the
unit pauses one second after sending CED, which
allows echo suppression to restart. This may help
with problematic overseas reception.
0 1 1 1 1
1 0 0 0 0
1 0 0 1 1
1 0 1 0 1
Initial setting for MFX-1700/1600
Usage/Comments
Adjusts the T1 time-out. After the machine dials the
remote machine's phone number, it begins sending
CNG and waits this amount of time before
disconnecting the line.
If the received document includes the RTC, the unit
print the data even though the following protocol is
not succeeded.
Set to "1" if a compatibility error occurs because the
transmitting machine does not understand the
extended frame for ITU-T superfine resolution.
(Note: Setting this switch to "1" will disable superfine
mode.)
1
1
3-25
1 1
1 1
0 0
0 1