Commands; Command List - A&D GF-30K Instruction Manual

17. Commands

17-1. Command List

Note A command has a terminator added, that is specified using "
function table, and is sent to the balance.
Commands to query weighing data
C
Q
S
SI
SIR
Commands to control the balance
?CN
?HI
?ID
?LO
?MA
?MQnnn
?MX
?PN
?PT
?SN
?TN
?UN
?UW
CAL
CN:mm
HI:∗∗∗∗∗∗.∗~~g
ID:∗∗∗∗∗∗∗
LO:∗∗∗∗∗∗.∗~~g
MCL
MD:nnn
OFF
ON
P
PN:mm
PRT
PT:∗∗∗∗∗.∗~~g
Cancels the S or SIR command.
Requests the weighing data immediately.
Requests the weighing data when stabilized.
Requests the weighing data immediately.
Requests the weighing data continuously.
Requests the upper/lower limit value code number of the selected value.
Requests the upper limit value.
Requests the identification number.
Requests the lower limit value.
Outputs all weighing data in memory.
Outputs data with the data number nnn. nnn: Three digits
Outputs the number of data in memory (the last data number)
Request the tare number of the selected value.
Request the tare value.
Request the serial number of the balance.
Request the model name of the balance.
Requests the unit mass numbers in memory.
Requests the unit mass value.
Same as the key.
CAL
Recalls the upper/lower limit value in memory. mm: 01 to 20.
Sets the upper limit values. ~ is space mark.
Example: the upper limit value is 2000.0 g.
Command: HI:+002000.0~~g
Sets identification number.
Sets the lower limit values. ~ is space mark.
Example: the lower limit value is 1000.0 g.
Command :LO:+001000.0~~g
Deletes all data in memory.
Deletes data with the data number nnn. nnn: Three digits.
Turns the display off.
Turns the display on.
Same as the
ON:OFF
Recalls the tare value in memory. mm: 01 to 20.
Same as the
PRINT
Sets the tare value. ~ is space mark.
Example: the tare value is 1000.0 g.
Command :PT:+001000.0~~g
key
key
83
5if Crlf
" of the