A&D GF-30K Instruction Manual page 68

12-5-2. Recalling the upper and lower limit values
(Quick selection mode)
The procedure below describes an easy way to recall the upper and lower limit values to be
used for weighing. When the recalled upper and lower limit values are to be changed, refer
to "12-5-1. Storing the upper and lower limit values".
Note
Refer to "12-5-1. Storing the upper and lower limit values" for the method to store the
upper and lower limit values.
Step 1 Set the "Data memory (
Step 2 Press the
limit value recalling mode. The upper limit value
last selected with its comparator number appears.
The display is as shown to the right, with all the
digits blinking.
Step 3 Press the
time the
value changes as follows:
( ........ ↔
C03
C04
LO
Step 4 Press the
balance returns to the weighing mode with the
selected upper and lower limit values ready for use.
To cancel the selection, press the
balance returns to the weighing mode.
Note
When no operation is performed in step 4 (after a few seconds of inactivity), the
balance selects the value currently displayed and returns to the weighing mode
automatically.
)" parameter to "
data
key to enter the upper/lower
MODE
key to select the value. Each
MODE
key is pressed, the displayed
MODE
↔
C03
HI LO
↔ ........ )
key to confirm the selection. The
PRINT
".
4
↔ ↔
C04
HI
key. The
CAL
66
Comparator
number
Store
Comparison with
no.
04
Upper
limit
Lower
limit
Target
Number