Initializing The Balance - A&D GF-30K Instruction Manual

Function table
0
1
Not used
Calibration using an external weight
0
1
Not used

9-2. Initializing The Balance

This function returns the following parameters to factory settings.
Calibration data
Function table
The sample unit mass value (counting mode),
100% reference mass value (percent mode)
The data that is stored in the balance using the data memory function
External calibration weight and target weight value
Function switch settings
Liquid density and temperature in the density mode
Note Be sure to calibrate the balance after initialization.
Step 1 Press the
Step 2 While pressing and holding the
the
SAMPLE
display
p5
Step 3 Press the
Step 4 Press the
To cancel this operation, press the
Step 5 Press the
Step 6 Press the
The balance will automatically return to the weighing
mode.
GF-K series. The display shown left indicates the factory settings.
To inhibit changes to the function table.
To permit changes to the function table.
To inhibit calibration using an external weight.
To permit calibration using an external weight.
key to turn off the display.
ON:OFF
key, press the
.
key to display
SAMPLE
key.
PRINT
key to display
RE-ZERO
key to initialize the balance.
PRINT
key and
PRINT
key to
ON:OFF
.
Clr
key.
CAL
.
Clr go
32
With these keys Press the key
held down