A&D GF-30K Instruction Manual page 64

Using the "UN:mm" command, the unit mass can be recalled.
The unit mass recalled can be output using the "?UW" command.
The unit mass can be changed using the "UW:" command.
"mm" indicates a two-digit numerical value 01 to 50, which corresponds to p01 - p50 of the
GX-K series.
"mm" indicates a two-digit numerical value 01 to 20, which corresponds to p01 - p20 of the
GF-K series.
Weighing input mode
In the weighing input mode, the specified number of samples is placed on the pan to store
the unit mass. Re-storing the unit mass or performing Automatic Counting Accuracy
Improvement (ACAI) on the re-stored unit mass is possible. Follow the procedure described
in "6-2. Counting Mode (PCS)".
Use the following keys to store a unit mass in the weighing input mode.
key .. To set the display to zero.
RE-ZERO
key ... To change the number of samples to be stored.
SAMPLE
key ....... Press, after a sample is placed, to store the unit mass. Go to step 3 of the
PRINT
key .......... To return to the unit mass confirmation mode. Go to step 3 of the
CAL
key ....... Press and hold to go to the digital input mode.
MODE
Digital input mode
To use this mode, the sample unit mass must be known
beforehand. In the digital input mode, the unit mass value is
entered digitally using the keys. The display in the digital input
mode is shown to the right.
Note ACAI can not be used on the unit mass stored
using the digital input mode.
Use the following keys to store a unit mass in digital input mode.
key ... To select the digit to be changed.
SAMPLE
key .. To change the value of the selected digit.
RE-ZERO
key ...... To change the decimal point position.
MODE
key ....... To store the unit mass. Go to step 3 of the previous page.
PRINT
key .......... To return to the unit mass confirmation mode. Go to step 3 of the
CAL
key ....... Press and hold to go to the weighing input mode.
MODE
Note If the new unit mass is out of the setting range, "
Refer to "20. Specifications" for the minimum unit mass.
previous page.
previous page.
previous page.
→
10 - pcs 10 0 pcs
Decimal point
error 2
62
→
10 0 pcs 25 0 pcs
Value
" is displayed.
Digit
Store