A&D GF-30K Instruction Manual page 80

Entering the density directly (
The density currently set (unit : g / cm
Use the following keys to change the value.
The range to set the density is 0.0000g / cm
RE-ZERO
SAMPLE
key ........ To store the change, display
PRINT
key ........... To cancel the change and return to the density mode.
CAL
Outputting the density.
Step 4 After all the necessary parameters have been set, press
the
SAMPLE
The density is displayed with three decimal places.
key ... To set the value of the digit selected.
key .... To select the digit to change the value.
(Go to "Step 2 Selecting a parameter to set")
(Go to "Step 2 Selecting a parameter to set")
key to output the density calculated.
)
ldin 1
3
, factory setting : 1.0000g / cm
3
to 1.9999g / cm
and return to the density mode.
end
78
3
) is displayed.
3
.
Calculated result