Clock And Calendar Function - A&D GF-30K Instruction Manual

10-7. Clock And Calendar Function

The GX-K series is equipped with a clock and calendar function. When the "GLP output
( )" parameter is set to "
info
" ", " " or " ", the time and date are added to the output data. Set or confirm the time and
1 2 3
date as follows:
Note GF-K series does not use this function.
Operation
Step 1 Press and hold the
the weighing mode, then release the key.
Step 2 Press the
Step 3 Press the
The balance enters the mode to confirm or set the time and date.
Confirming the time
Step 4 The current time is displayed with all the digits blinking.
When the time is correct and the date does not need to be
confirmed, press the
When the time is correct and the date is to be confirmed,
press the
When the time is not correct and is to be changed, press
the
RE-ZERO
Setting the time (with part of the digits blinking)
Step 5 Set the time in 24-hour format using the following keys.
SAMPLE
RE-ZERO
key ...... To decrease the value by one.
MODE
key ...... To store the new setting, display
PRINT
key ......... To cancel the new setting and go to step 6.
CAL
Confirming the date
Step 6 The current date is displayed with all the digits blinking.
To change the display order of year (y), month (m) and day (d),
press the
specified.
When the date is correct and the operation is to be
finished, press the
When the time is to be confirmed again, press the
key and go back to step 4.
When the date is not correct and is to be changed, press
the
RE-ZERO
Note The year is expressed using a two-digit format.
For example: The year 2004 is expressed as "04".
" or " " and the "Time/Date output (
1 2
SAMPLE
key several times to display
SAMPLE
key.
PRINT
key and go to step 8.
CAL
key and go to step 6.
SAMPLE
key and go to step 5.
key ... To select the digits to change the value.
The selected digits blink.
key .. To increase the value by one.
and go to step 6.
key. The date is output in the order as
MODE
key and go to step 8.
CAL
key and go to step 7.
key until of the function table is displayed in
ba5fnc
45
)" parameter is set to
5-td
.
Cl adj
end
Goes to date
setting mode
SAMPLE
Store