Port-Based Vlan Commands - ZyXEL Communications XS3800-28 Cli Reference Manual

Use these commands to configure port-based VLAN.
Note: These commands have no effect unless port-based VLAN is enabled.
67.1 Command Summary
The following section lists the commands for this feature.
Table 165 egress Command Summary
COMMAND
show interfaces config <port-
list> egress
vlan-type <802.1q|port-based>
interface port-channel <port-
list>
egress set <port-list>
no egress set <port-list>
67.2 Command Examples
This example looks at the ports to which incoming traffic from ports 1 and 2 can be forwarded.
sysname# show interfaces config 1-2 egress
Port 1: Enabled egress ports cpu, eg1
Port 2: Enabled egress ports cpu, eg1-eg4
Port-based VLAN
DESCRIPTION
Displays outgoing port information for the specified ports.
Specifies the VLAN type.
Enters config-interface mode for the specified port(s).
Sets the outgoing traffic port list for a port-based VLAN.
Removes the specified ports from the outgoing traffic port
list.
Ethernet Switch CLI Reference Guide
255
C
H A P T E R
Commands
67
M P
E 3
C 13
C 13
C 13
C 13