Chapter 14 Link Aggregation
Table 33 Advanced Application > Link Aggregation > Link Aggregation Setting (continued)
LABEL
Active
Port
Group
Apply
Cancel
14.5 Link Aggregation Control Protocol
Click in the Advanced Application > Link Aggregation > Link Aggregation Setting >
LACP to display the screen shown next. See
on dynamic link aggregation.
Figure 53 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
114
DESCRIPTION
Select this option to activate a trunk group.
This field displays the port number.
Select the trunk group to which a port belongs.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
Section 14.2 on page 111
for more information
GS-2024 User's Guide