Front Riggings; Installing/Removing Footrests - Invacare Solara 3G User Manual

7 FRONT RIGGINGS

7 Front Riggings
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise
injury or damage may occur
7.1

Installing/Removing Footrests


This procedure applies to the lift off footrest assembly and elevating legrest.
Installing
1. Turn footrest to the side (open footplate is perpendicular to the wheelchair).
2. Insert the footrest assembly mounting pin into the mounting tube of the wheelchair frame.
3. Rotate the footrest towards the inside of the wheelchair until it locks into place.
4. The footplate will be on the inside of the wheelchair when locked in place.
5. Repeat STEPS 1-3 for the other footrest assembly.
6. If necessary, adjust the footrest height. Refer to Adjusting Footrest Height on page 39 or Adjusting Footplate Height and Calfpad Height/Depth
on page 45.
Removing
1. Push the footrest release lever inward while rotating the front rigging outward.
2. Lift the footrest assembly out of the mounting pin of the wheelchair frame.
3. Repeat STEPS 1-2 for opposite side, if necessary.
 Only the swing away footrest is shown. The lift off footrest assembly and elevating legrest install/remove in the same
manner.
Invacare® Solara®3G/Spree 3G Wheelchair
38
Part No 1154295