5.
Adjust the wheel locks. Refer to Wheel Lock Adjustment on page 88.
Only 12-inch rear wheel is shown. All other wheels will install/remove in the same manner.
Permanent Axle
To remove rear wheels, reverse this procedure.
1.
Remove the permanent axles from the packaged container.
2.
Install permanent axle through lock washer and the rear wheel and axle plate.
3.
Securely tighten the wheel to the wheelchair frame with locknut.
Only 12-inch rear wheel is shown. All other wheels will install/remove in the same manner
4.
Repeat STEPS 2-3 for other rear wheel assembly.
5.
Adjust the wheel locks. Refer to Adjusting The Quick-Release Axle on page 86.
Part No 1154295
Wheelchair Frame
Rear Wheel
Locking Pins
Detent Pin
Quick-Release Axle
FIGURE 1 Installing/Removing Rear Wheels
Axle
Mounting
Plate
85
Invacare® Solara®3G/Spree 3G Wheelchair
12 WHEELS/FORKS
.