Section 6-Front Riggings; Installing/Removing Footrests; 70°/Taper Pin Style; 60°, 70°, Mfx, Taper And 90 - Invacare 3G Storm Series Owner's Operator And Maintenance Manual

SECTION 6—FRONT RIGGINGS
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
While the wheelchair is moving, minimum ground clearance for the front rigging is
three inches. If the wheelchair is not moving, the front rigging MUST maintain a
minimum of one inch ground clearance - otherwise personal injury and damage may
result.
For the following procedures, make sure the ON/OFF switch on the joystick is in the
OFF position.

Installing/Removing Footrests

70°/Taper Pin Style
NOTE: For this procedure, refer to FIGURE 6.1.
1. Turn the footrest to the side (open
footplate is perpendicular to
wheelchair).
2. Install the hinge plates on the footrest
onto the hinge pins on the wheelchair
frame.
3. Push the footrest towards the inside of
the wheelchair until it locks into place.
NOTE: The footplate will be on the inside of the
wheelchair when locked in place.
4. Repeat STEPS 1-3 for other footrest
assembly.
5. To remove the footrest, push the footrest release lever inward, rotate footrest outward.
6. Adjust footrest height if desired. Refer to Footrest Height Adjustment on page 64.
60°, 70°, MFX, Taper and 90°
NOTE: For this procedure, refer to FIGURE 6.2 on page 64.
1. Turn the footrest to the side (open footplate is perpendicular to wheelchair itself).
2. Insert footrest mounting pin into mounting tube.
3. Push the footrest towards the inside of the wheelchair until it locks into place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4. Repeat STEPS 1- 3 for the other footrest assembly.
Part No 1134791
All manuals and user guides at all-guides.com
WARNING
63
SECTION 6—FRONT RIGGINGS
Hinge
Pins
Footrest
FIGURE 6.1 Installing/Removing Footrests -
70°/Taper Pin Style
3G Storm Series® Wheelchairs
Footrest
Release Lever
Hinge
Plate