Invacare Solara 3G User Manual page 40

7 FRONT RIGGINGS
4. Securely tighten the hex screw and coved spacer.
5. Install the footrest assembly onto the wheelchair. Refer to Installing/Removing Footrests on page 38.
6. Repeat STEPS 1-5 for the opposite side of the wheelchair, if necessary.
70° MFX, 90°, 70° LIFT and 90° LIFT Footrests.
1. Remove any accessories that are attached to the footrests.
2. Remove the socket bolt, coved washer and locknut that secure the footplate to the footrest support.
3. Reposition the footplate to the desired height.
4. Reinstall the socket bolt through the mounting holes of the footplate and footrest support.
WARNING
DO NOT overtighten socket bolt and locknut. Footrest MUST be able to rotate upward from the horizontal to the vertical
position.
5. Secure the footplate to the footrest support with the coved washer and locknut.
Invacare® Solara®3G/Spree 3G Wheelchair
Hex Screw
Coved
Spacer
Footrest
FIGURE 2 Adjusting Footrest Height - 60°, 70° and 70° Taper
Footrest Upper
Support
Mounting
Tube
40
Part No 1154295