Using/Installing/Adjusting Non-Locking Cantilever Arms - Invacare Solara 3G User Manual

8 ARMS
8.9

Using/Installing/Adjusting Non-Locking Cantilever Arms

WARNING
DO NOT use lap trays with non-locking cantilever arms.
Using Non-Locking Cantilever Arms
1. Pull the end of the cantilever arm down to lower the cantilever arm.
2. Pull the end of the cantilever arm up to move it out of the way.
Installing Non-Locking Cantilever Arms
1. Remove the locknut and washer from the lower hex bolt installed
on the non-locking cantilever arm.
2. Slide hex bolt of the cantilever arm assembly into the desired back
cane mounting hole.
3. Secure the cantilever arm to the wheelchair with a washer and
locknut.
4. Adjust the angle of the cantilever arm, if necessary. Refer to
Adjusting Non-Locking Cantilever Arm Angle on page 65.
Invacare® Solara®3G/Spree 3G Wheelchair
Back Cane
Cantilever Arm
FIGURE 14 Installing Non-Locking Cantilever Arms
Adjusting Locking Cantilever Arm Height..
64
Back Cane
Coved Washers
and Spacer
Washer
Cantilever
Lower Hex
Bolt
Part No 1154295
Locknut
Arm