Recliner Back Option; Recliner Operation - Invacare Solara 3G User Manual

14 RECLINER BACK OPTION

14 Recliner Back Option
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise
injury or damage may result.
The back height, seat depth, back angle, seating system, tilt angle, seat height, size/position of the rear wheels, size/position
of the front casters, as well as the user condition directly relate to the stability of the wheelchair. Any change to one or any
combination of the eleven may cause the wheelchair to decrease in stability. These adjustments MUST be performed by a
qualified technician.
CAUTION
DO NOT overtighten hardware attaching to the frame. This could cause damage to the frame tubing.

14.1 Recliner Operation

WARNING
Both gas cylinders MUST be operational and adjusted properly before using the recliner. DO NOT operate the recliner
option if only one of the gas cylinders is operational or adjusted properly.
ALWAYS make sure that the wheelchair is stable in the full reclined (back at 180°) position and the full upright (back at 90°)
position before using the recliner option.
Make sure the patient is properly positioned in the wheelchair before reclining or inclining (sitting up) to maintain maximum
stability and safety.
ALWAYS engage both wheel locks while reclining or inclining (sitting up) the wheelchair.
Invacare® Solara®3G/Spree 3G Wheelchair
98
Part No 1154295