Section 7-Front Riggings/Footboard; Installing/Removing Front Riggings; Installing; Removing - Invacare Pronto M71 Service Manual

SECTION 7—FRONT RIGGINGS/FOOTBOARD
SECTION 7—FRONT RIGGINGS/
FOOTBOARD
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that ON/OFF
switch on the joystick is in the OFF position.

Installing/Removing Front Riggings

If non-hemi front riggings are used, then the seat MUST be adjusted to the highest
mounting position - otherwise damage may occur.
NOTE: For this procedure, refer to FIGURE 7.1.

Installing

1. If necessary, remove the footboard. Refer to Removing/Installing the Footboard
Assembly on page 71.
2. Turn front rigging to the side (open footplate is perpendicular to wheelchair) and
position mounting holes in the front rigging hinge plates with hinge pins on the
wheelchair frame.
3. Install the front rigging hinge plates onto the hinge pins on the wheelchair frame.
4. Push the front rigging towards the inside of the wheelchair until it locks into place.
NOTE: The footplate will be on the inside of the
wheelchair when locked in place.
5. Repeat STEPS 1-4 for opposite side of
wheelchair.

Removing

1. Push the front rigging release lever
inward and rotate the footrest outward.
2. Lift up on front rigging and remove
from the wheelchair.
3. Repeat STEPS 1-2 for opposite side of
wheelchair.
Pronto® M71™
All manuals and user guides at all-guides.com
WARNING
CAUTION
66
Telescoping Front
Hinge
Pins
Front
Front
Rigging
Rigging
Release
Hinge
Lever
Plate
FIGURE 7.1 Installing/Removing Front
Riggings
Rigging Support
Part No 1118377