Installing/Removing Non-Adjustable Stroller Handles; Adjusting The Adjustable Angle Stroller Handles - Invacare Solara 3G User Manual

9.4

Installing/Removing Non-Adjustable Stroller Handles

Installing Stroller Handles
1. Remove plug buttons from both back canes, if necessary.
2. Slide stroller handle into the back canes.
3. Align the mounting holes of the stroller handle and the back canes.
4. Insert bolt through the back cane and stroller handle.
5. Secure the stroller handle to the back cane with the bolt and nut.
6. Pull on the stroller handle to make sure it is locked securely in
place.
Removing Stroller Handles
1. Remove the locknuts that secure the stroller handle to the back
cane.
2. Pull out the bolts that secure the stroller handle to the back canes.
3. Remove the stroller handle from the wheelchair.
9.5

Adjusting the Adjustable Angle Stroller Handles

1. Press and hold in both buttons on the outside of the hinge arm of the stroller handle.
2. Adjust stroller handle to desired angle.
3. Release the buttons.
4. Push down on stroller handle to ensure hinge arms hold the desired position of the stroller handle.
There will be an audible click.

If hinge arms do not hold the position, contact Invacare technical support
Part No 1154295
4. Install the new stroller handle if desired. Refer to Installing Stroller
Handles on page 71.
Bolt
FIGURE 5 Installing/Removing Non-Adjustable Stroller
71
Invacare® Solara®3G/Spree 3G Wheelchair
9 BACK/SEAT
Stroller Handle
Locknut
Mounting Holes
Back Cane
Handles