Angle Adjustment - Invacare Solara 3G User Manual

3. Retighten the two flat screws and locknuts.

The setting for positioning the footplate on the half clamp may vary for each footplate.
4. Repeat STEPS 1-3 for opposite footplate, if desired.

Angle Adjustment

1. Loosen, but DO NOT remove the adjustment screw in the half clamp.
2. Position the footplate to the necessary angle to accommodate the user (Detail "A").
3. Retighten the adjustment screw. Torque to over 90 in-lbs, but no more than 300 in-lbs.
4. Repeat STEPS 1-3 for opposite footplate, if desired.
5. Screw in or out until the adjustable angle flip-up footplate is perpendicular to the footrest assembly or the desired inversion/eversion is obtained.
Footrest Support
Footplate
Detail "A" - Side
View of Footplate and
Footrest Support
Part No 1154295
FIGURE 5 Adjusting Adjustable Angle Flip-Up Footplates
43
90° Footrest Support
Flat Screws
Footplate
Half Clamp
Adjustment Screw
Invacare® Solara®3G/Spree 3G Wheelchair
7 FRONT RIGGINGS
Footplate
Hinge
Locknuts