8 ARMS
8.4
Replacing Conventional Armrest Pads
1.
Remove the mounting screws that secure the existing armrest pad
to the armrest assembly.
2.
Install new armrest pad and securely tighten with the existing
mounting screws.
8.5
Installing/Removing T-Arms
Installing T-Arms
1.
Position the T-Arm over the T-Arm socket on the wheelchair frame.
Make sure the locking lever is towards the front of the wheelchair.
2.
Slide T-Arm into T-Arm socket until the locking lever is in the slot in the T-Arm socket and an audible "click" is heard.
3.
Pull up on T-Arm to make sure T-Arm is locked in place..
If the T-Arm does not slide in the T-Arm socket as desired, adjust the T-Arm socket. Refer to Adjusting T-Arm Sockets. on
page 59.
4.
Adjust the T-Arm for desired height, width and depth, if necessary. Refer to Adjusting The T-Arms on page 56.
5.
Repeat STEPS 1-4 for opposite side of wheelchair.
Invacare® Solara®3G/Spree 3G Wheelchair
Armrest
Assembly
Mounting
Screws
FIGURE 5
Replacing Conventional Armrest Pads
54
Armrest Pad
Part No 1154295