Adjusting T-Arm Sockets - Invacare Solara 3G User Manual

8.7

Adjusting T-Arm Sockets


Perform this procedure if the T-Arm is too loose in the socket or does not easily slide UP and DOWN in the socket
1. Remove the rear wheels from the wheelchair, if necessary. Refer to
Installing/Removing Rear Wheels on page 84.
2. Loosen, but DO NOT remove the four hex screws and washers
that secure T-Arm socket to T-Arm clamp..
The T-Arm socket will disassemble if the four hex

screws and washers are removed
3. Slide the T-Arm into the T-Arm socket until the locking lever is in
the slot in the T-Arm socket and an audible "click" is heard.
4. Squeeze the T-Arm socket and the T-Arm clamp together until the
socket is flush with the T-Arm.
5. While holding the T-Arm socket and the T-Arm clamp together,
tighten the four hex screws and washers. Tighten securely.
6. Press IN on the locking lever and lift the T-Arm straight UP and out
of the T-Arm socket.
7. Repeat STEPS 3-6, if necessary until the T-Arm slides in the T-Arm
socket as desired.
8. If necessary, install rear wheels. Refer to Installing/Removing Rear
Wheels on page 84.
Part No 1154295
.
.
T-Arm
Hex Screws
and Washers
Slot
Locking Lever
FIGURE 9
59
Invacare® Solara®3G/Spree 3G Wheelchair
T-Arm Clamp
Hex Screws and
Washers
T-Arm Socket
Adjusting T-Arm Sockets.
8 ARMS
.