Table of Contents
Advertisement
SECTION 6—FRONT RIGGINGS
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
For the following procedures, make sure the On/Off switch on the joystick is in the
OFF position.
DO NOT stand on the flip-up footboard. When getting in or out of the wheelchair,
make sure that the flip-up footboard is in the upward position.
PINCH POINT EXISTS BETWEEN CENTER MOUNT FOOTREST AND
CASTERS - There is limited clearance between center mount footrest and casters.
The user's feet MUST remain on the center mount footrest while operating the
wheelchair. If the user's feet are allowed to rest off the side of the center mount
footrest they may come in contact with the caster possibly resulting in injury.
While the wheelchair is moving, minimum ground clearance for the front rigging is
three inches. If the wheelchair is not moving, the front rigging MUST maintain a
minimum of one inch ground clearance - otherwise personal injury and damage may
result.
Installing/Removing Footrests
PHAL4A, 70° and PW93
NOTE: For this procedure, refer to
FIGURE 6.1.
1. Turn the footrest to the side (open
footplate is perpendicular to
wheelchair).
2. Install the hinge plates on the footrest
onto the hinge pins on the wheelchair
frame.
3. Push the footrest towards the inside of
the wheelchair until it locks into place.
NOTE: The footplate will be on the inside of the
wheelchair when locked in place.
4. Repeat STEPS 1-3 for other footrest assembly.
5. To remove the footrest, push the footrest release lever inward, rotate footrest outward.
6. Adjust footrest height, if desired. Refer to Footrest Height Adjustment on page 36.
Part No 1122170
All manuals and user guides at all-guides.com
WARNING
35
SECTION 6—FRONT RIGGINGS
Hinge
Pins
Hinge Plate
Footrest
FIGURE 6.1 Installing/Removing Footrests -
Phal4A, 70° and pw93
Formula™ Powered Seating
Footrest Release
Lever
Advertisement
Table of Contents
Troubleshooting
