Using/Installing/Adjusting Locking Cantilever Arms - Invacare Solara 3G User Manual

Using/Installing/Adjusting Locking Cantilever
Arms
Using Locking Cantilever Arms
1. Push the locking mechanism actuator towards the front of the
wheelchair.
2. While holding the locking mechanism actuator, pull up on the
cantilever arm towards the rear of the wheelchair.
 If necessary, the locking mechanism in the
cantilever arm can be repositioned so the
cantilever arm will open down instead of up. For
this adjustment, contact a qualified technician.
3. To lock the cantilever arm, push down until there is an audible click.
4. Pull up on the cantilever arm to make sure it is locked in place.
Installing Locking Cantilever Arms
 When removing the locknuts and washers from the cantilever arm assembly, leave the top hex bolt, coved washers and
spacer (between adjustment plate and cantilever arm) in place.
1. Slide the partially assembled cantilever arm assembly with mounting hardware through the back cane. Make sure the adjustment plate is towards
the inside of the wheelchair..

This includes top hex bolt, coved washers and spacer (between adjustment plate and cantilever arm.
2. Slide the bottom hex bolt (w/coved washer) through the adjustment plate and back cane.
3. Securely tighten the cantilever arm to the wheelchair with two locknuts and washers.
4. Adjust the angle of the cantilever arm, if necessary. Refer to Adjusting the Locking Cantilever Arm Angle on page 63.
Part No 1154295
.
61
Front of Wheelchair
Rear of
Wheelchair
Push
Locking
Mechanism
Actuator
FIGURE 11 Using Locking Cantilever Arms
Invacare® Solara®3G/Spree 3G Wheelchair
8 ARMS
Cantilever Arm