Invacare Solara 3G User Manual page 63

Adjusting the Locking Cantilever Arm Angle

This adjustment is recommended if the back angle has been changed to keep arm parallel to the ground/floor.
1. Flip the cantilever arm up and out of the way.
2. Remove the locknut that secures the locking pin to the arm adjustment plate.
3. Determine the mounting hole in the arm adjustment plate that will be used to correspond to the back angle.
4. Securely tighten the locking pin and washer to the adjustment plate with a locknut.
5. Repeat STEPS 1-4 for the opposite side, if necessary.
Arm Adjustment
Plate
Locking Pin
Washer
Part No 1154295
Back Angle Bracket
90°
Locknut
Back Angle Bracket
110°
FIGURE 13 Adjusting the Locking Cantilever Arm Angle
Arm Adjustment Plate
Arm Adjustment
Plate
63
Invacare® Solara®3G/Spree 3G Wheelchair
Back Angle Bracket
Arm Adjustment
100°
Arm Adjustment
Back Angle Bracket
120°
8 ARMS
Plate
Plate