Back Up Or Restore The Configuration File; Back Up The Ap Configuration Settings - NETGEAR WAX220 User Manual

Essentials WiFi 6 AX4200 Dual Band Multi-Gig Access Point Model WAX220
4. Select Management > System Manager > Firmware.
The page that displays shows the Automatic Firmware Upgrade Check section and
the Firmware Upgrade section.
5. Locate and select the firmware file on your computer by doing the following:
a. In the Firmware Upgrade section, click the Choose File button.
b. Navigate to the firmware file.
The file name ends in .img.
c. Select the firmware file.
6. Click the Upload button.
The page displays the update progress.
WARNING: To avoid the risk of corrupting the firmware, do not interrupt the update.
For example, do not close the browser, click a link, or load a new page. Do not turn
off the AP. Wait until the AP finishes.
When the update is finished, you can log back into the AP. After you log in, the
firmware version displays on the Dashboard page.

Back up or restore the configuration file

The configuration settings of the AP are stored within the AP in a configuration file. You
can back up (save) this file to your computer. After you do so, you can restore the
configuration from the file.

Back up the AP configuration settings

You can save a copy of the current configuration settings. If necessary, you can restore
the configuration settings later.
To back up the AP's configuration settings:
1. Launch a web browser from a computer or tablet that is directly connected over WiFi
to the AP or connected to the same network as the AP.
2. Enter the IP address that is assigned to the AP.
If you are directly connected to the management WiFi network, you can enter
https://www.aplogin.net.
A login page displays.
Maintain the AP 82 User Manual