Region & Timer Settings; Auto Reset Timer; Auto Print Timer - Fuji Xerox DocuCentreS2520 User Manual

8 Tools
Region & Timer Settings
Region
Sets the machine's region of use.
You can select from [Australia], [China], [Taiwan], [Hong Kong], [Indonesia], [Korea],
[Malaysia], [New Zealand], [Philippines], [Singapore], [Vietnam], or [Thailand].
[Australia] is set at the time of factory shipment.
Important • If you change the [Region] setting after you have started using the machine, all the settings will be
Follow the steps below to make the settings.
1
In the [Region & Timer Settings] screen, select
[Region].
2
Press the <OK> button.
3
Select your region, and then press the <OK>
button.
4
Select [Yes (Restart Required)], and then press
the <OK> button.
Restart the machine (turn the power OFF and
8
then turn it back ON again).

Auto Reset Timer

Sets the amount of time the machine waits before automatically returning to the Default
Display screen when no operation is being performed.
You can select [15 seconds], [30 seconds], [45 seconds], [1 minute], [2 minutes], [3 minutes],
or [4 minutes].
[45 seconds] is set at the time of factory shipment.

Auto Print Timer

Used to set the amount of time the machine waits after operating the control panel, loading
paper on the document feeder, or closing a tray until starting to print automatically.
You can set a value between 1 and 240 seconds (in 1 second increments).
[10 seconds] is set at the time of factory shipment.
Power Saver Timer
Used to make settings for the Power Saver function.
 Low Power Mode
Sets the amount of time the machine waits before entering Low Power mode.
You can set a value between 1 and 60 minutes (in 1 minute increments).
142
reset. Change the [Region] setting with care.
Region & Timer Settings
Region... Australia
Auto Reset Timer... 45 seconds
Auto Print Timer... 10 seconds
Region
Australia
China
Taiwan
Apply Settings [Are You Sure?]
No
Yes (Restart Required)