Table of Contents
Advertisement
Verifying the IPv6 Configuration
Verifying the IPv6 Configuration
A summary of the show commands used for verifying the IPv6 configuration is given here:
show ipv6 rip
show ipv6 redist
show ipv6 interface
show ipv6 tunnel configured
show ipv6 tunnel 6to4
show ipv6 routes
show ipv6 route-pref
show ipv6 router database
show ipv6 prefixes
show ipv6 neighbors
show ipv6 tcp listeners
show ipv6 tcp connections
show ipv6 icmp statistics
show ipv6 pmtu table
show ipv6 tcp connections
show ipv6 tunnel 6to4
For more information about the displays that result from these commands, see the OmniSwitch CLI Refer-
ence Guide.
page 13-26
Displays the RIPng status and general configuration parameters.
Displays the route map redistribution configuration.
Displays the status and configuration of IPv6 interfaces.
Displays IPv6 configured tunnel information.
Displays IPv6 6to4 tunnel information.
Displays the IPv6 Forwarding Table.
Displays the configured route preference of a router.
Displays a list of all routes (static and dynamic) that exist in the IPv6
router database.
Displays IPv6 subnet prefixes used in router advertisements.
Displays the IPv6 Neighbor Table.
Displays statistics for IPv6 listener traffic.
Displays statistics for IPv6 connection traffic.
Displays ICMP6 statistics.
Displays the IPv6 Path MTU Table.
Displays TCP Over IPv6 Connection Table. Contains information
about existing TCP connections between IPv6 endpoints.
Displays the UDP Over IPv6 Listener Table. Contains information
about UDP/IPv6 endpoints.
OmniSwitch AOS Release 7 Network Configuration Guide
Configuring IPv6
March 2011
Advertisement
Table of Contents
