Table of Contents
Advertisement
Verifying the Port Mapping Configuration
•
Ports 2/1 and 2/2 on Switch D do not interact with each other but they interact with all the user ports on
Switch A except 3/1, 3/2, and 3/3. They also interact with all the ports on Switch B and Switch C.
•
Ports 3/1, 3/2, and 2/1 on Switch C can interact with all the user ports on the network except 3/1, 3/2,
and 3/3 on Switch A.
Example Port Mapping Configuration Steps
The following steps provide a quick tutorial to configure the port mapping session shown in the diagram
on
page
24-5.
1
Configure session 1 on Switch A in the unidirectional mode using the following command:
-> port-mapping 1 unidirectional
2
Create two port mapping sessions on Switch A using the following commands:
-> port-mapping 1 user-port 2/1-2 network-port 1/1-2
-> port-mapping 2 user-port 3/1-3 network-port 1/3
3
Enable both the sessions on Switch A using the following commands:
-> port-mapping 1 enable
-> port-mapping 2 enable
4
Similarly, create and enable a port mapping session 1 on Switch D using the following commands:
-> port-mapping 1 user-port 2/1-2 network-port 1/1
-> port-mapping 1 enable
Verifying the Port Mapping Configuration
To display information about the port mapping configuration on the switch, use the show commands listed
below:
show port-mapping status
show port-mapping
For more information about the displays that result from these commands, see the
OmniSwitch CLI Reference Guide.
page 24-6
Displays the status of one or more port mapping sessions.
Displays the configuration of one or more port mapping sessions.
OmniSwitch AOS Release 7 Network Configuration Guide
Configuring Port Mapping
March 2011
Advertisement
Table of Contents
