Modifying Dynamic Link Aggregate Group Parameters
Modifying the Dynamic Aggregate Group Partner System Priority
By default, the dynamic aggregate group partner system priority is 0. The following subsections describe
how to configure a user-specified value and how to restore the value to its default value with the
linkagg lacp agg partner system-priority
Configuring a Dynamic Aggregate Group Partner System Priority
You can modify the dynamic aggregate group partner system priority to a value by entering linkagg lacp
agg followed by the dynamic aggregate group number, partner system-priority, and the new priority
value.
For example, to set the partner system priority on dynamic aggregate group 4 to 2000, enter:
-> linkagg lacp agg 4 partner system-priority 2000
Restoring the Dynamic Aggregate Group Partner System Priority
To restore the dynamic aggregate group partner system priority to its default (0) value use the no form of
the
linkagg lacp agg partner system-priority
dynamic aggregate group number and partner system-priority.
For example, to reset the partner system priority of dynamic aggregate group 4 to its default value, enter:
-> no linkagg lacp agg 4 partner system-priority
Modifying the Dynamic Aggregate Group Partner System ID
By default, the dynamic aggregate group partner system ID is 00:00:00:00:00:00. The following
subsections describe how to configure a user-specified value and how to restore it to its default value with
the
linkagg lacp agg partner system-id
Configuring a Dynamic Aggregate Group Partner System ID
You can configure the dynamic aggregate group partner system ID by entering linkagg lacp agg followed
by the dynamic aggregate group number, partner system-id, and the user-specified MAC address (in the
hexadecimal format of xx:xx:xx:xx:xx:xx), which is used as the system ID.
For example, to configure the partner system ID as 00:20:da:81:d5:b0 on dynamic aggregate group 4,
enter:
-> linkagg lacp agg 4 partner system-id 00:20:da:81:d5:b0
Restoring the Dynamic Aggregate Group Partner System ID
To remove the user-configured partner switch system ID from the configuration of a dynamic aggregate
group, use the no form of the
agg followed by the dynamic aggregate group number and the partner system-id parameter.
For example, to remove the user-configured partner system ID from dynamic aggregate group 4, enter:
-> no linkagg lacp agg 4 partner system-id
page 7-16
command.
command by entering no linkagg lacp agg followed by the
command.
linkagg lacp agg partner system-id
OmniSwitch AOS Release 7 Network Configuration Guide
Configuring Dynamic Link Aggregation
command by entering no linkagg lacp
March 2011