Configuring 802.1AB
Setting the Transmit Fast Start Count
To set the fast start count in order to transmit the LLDP-MED Network Policy TLV in LLDPDU as soon
as the OmniSwitch detects a new MED capable endpoint device, enter the
command.
-> lldp transmit fast-start-count 3
Setting the Reinit Delay
To set the time interval that must elapse before the current status of a port is reinitialized after a status
change, enter the
lldp reinit delay
-> lldp reinit delay 7
Setting the Notification Interval
To set the time interval that must elapse before a notification about the local system Management Informa-
tion Base (MIB) change is generated, enter the
the notification value to 130 seconds, enter:
-> lldp notification interval 130
Note: In a specified interval, generating more than one notification-event is not possible.
OmniSwitch AOS Release 7 Network Configuration Guide
command. For example, to set the reinit delay to 7 seconds, enter:
lldp notification interval
March 2011
Configuring 802.1AB
lldp transmit fast-start-count
command. For example, to set
page 10-13