Enabling A Rip Host Route - Alcatel-Lucent OmniSwitch AOS Release 7 Manual

Enabling a RIP Host Route

A host route differs from a network route, which is a route to a specific network. This command allows a
direct connection to the host without using the RIP table. If a switch is directly attached to a host on a
network, use the ip rip host-route
-> ip rip host-route
The default is to enable a default host route.
Use the no ip rip host-route command to disable the host route. Use the show ip rip command to display
the current host route status.
OmniSwitch AOS Release 7 Network Configuration Guide
command to enable a default route to the host. For example:
March 2011 page 1511