Vrrpv3 Tracking Example - Alcatel-Lucent OmniSwitch AOS Release 7 Manual

Network configuration guide
Hide thumbs Also See for OmniSwitch AOS Release 7:
Table of Contents

Advertisement

Configuring VRRP
Note. The same VRRPv3 configuration must be set up on each switch. The VRRPv3 router that contains,
or owns, the IPv6 address will automatically become the master for that virtual router. If the IPv6 address
is a virtual address, the virtual router with the highest priority will become the master router.
In this scenario, the master of VRID 1 will respond to neighbor solicitation with a neighbor advertisement
for IPv6 address A using the virtual router MAC address for VRID 1 (00:00:5E:00:02:01). OmniSwitch
10K 1 is the master for VRID 1 since it contains the physical interface to which
assigned. If OmniSwitch 10K A should become unavailable, OmniSwitch 10K B will become master for
VRID 1.
In the same way, the master of VRID 2 will respond to neighbor solicitation for IPv6 address B using the
virtual router MAC address for VRID 2 (00:00:5E:00:02:02). OmniSwitch 10K B is the master for VRID
2 since it contains the physical interface to which
should become unavailable, OmniSwitch 10K A will become master for
tion provides uninterrupted service for the end hosts.

VRRPv3 Tracking Example

The figure below shows two VRRPv3 routers with two virtual routers backing up one IPv6 address on
each VRRPv3 router respectively. Virtual router 1 serves as the default gateway on OmniSwitch 10K A
for clients 1 and 2 through IPv6 address
the Internet on OmniSwitch 10K A fails, virtual router 1 will continue to be the default router for clients 1
and 2, but clients 1 and 2 will not be able to access the Internet.
port 3/1
213:100:1::56
VLAN 5
default gateway 213:100:1::56
OmniSwitch AOS Release 7 Network Configuration Guide
213:100:1::56
VRRPv3 Router
OmniSwitch A
VRID 1
Master 1
213:100:1::56
VRID 2
Backup 2
213:100:1::57
clients 1 and 2
VRRPv3 Tracking Example
is assigned. If OmniSwitch 10K B
213:100:1::57
213:100:1::57
. For example, if the port that provides access to
VRRPv3 Router
OmniSwitch B
Backup 1
Master 2
213:100:1::57
clients 3 and 4
default gateway 213:100:1::57
March 2011
VRRPv3 Application Example
s
213:100:1::56
. This configura-
port 3/1
Virtual Routers
page 18-31

Advertisement

Table of Contents
loading

This manual is also suitable for:

Omniswitch aos 7

Table of Contents