Verifying The Ip Configuration - Alcatel-Lucent OmniSwitch AOS Release 7 Manual

Verifying the IP Configuration

A summary of the show commands used for verifying the IP configuration is given here:
show ip interface
show ip routes
show ip route-pref
show ip router database
show ip config
show ip protocols
show ip router-id
show arp
show arp filter
show icmp control
show ip dos config
show ip dos statistics
show ip dos arp-poison
For more information about the displays that result from these commands, see the OmniSwitch CLI Refer-
ence Guide.
OmniSwitch AOS Release 7 Network Configuration Guide
Displays the usability status of interfaces configured for IP.
Displays the IP Forwarding table.
Displays the configured route preference of a router.
Displays a list of all routes (static and dynamic) that exist in the IP
router database.
Displays IP configuration parameters.
Displays switch routing protocol information and status.
Displays the current status of TCP/UDP service ports. Includes service
name and well-known port number.
Displays the ARP table.
Displays the ARP filter configuration for the switch.
This command allows the viewing of the ICMP control settings.
Displays the configuration parameters of the DoS scan for the switch.
Displays the statistics on detected port scans for the switch.
Displays the number of attacks detected for a restricted address.
March 2011 page 1137