Alcatel-Lucent OmniSwitch AOS Release 7 Manual page 487

Configuring IP Multicast Switching
An example of what these commands look like entered sequentially on the command line:
-> ip multicast admin-state enable
-> ip multicast static-neighbor vlan 5 port 1/5
-> ip multicast static-querier vlan 5 port 1/2
-> ip multicast robustness 7
As an option, you can use the
show ip multicast querier
-> show ip multicast
Status:
Querying:
Proxying:
Spoofing:
Zapping:
Querier Forwarding:
Version:
Robustness:
Query Interval (seconds):
Query Response Interval (milliseconds):
Last Member Query Interval(milliseconds):
Unsolicited Report Interval (seconds)
Router Timeout (seconds):
Source Timeout (seconds):
-> show ip multicast neighbor
Total 1 Neighbors
Host Address
---------------+-----+-----+-------+------+-----
1.0.0.2
-> show ip multicast querier
Total 1 Queriers
Host Address
---------------+-----+-----+-------+------+-----
1.0.0.3
OmniSwitch AOS Release 7 Network Configuration Guide
show ip multicast,
commands to confirm your settings as shown below:
VLAN Port Static
5 1/5 no
VLAN Port Static
5 1/2 no
show ip multicast neighbor, and
= Enabled
= Disabled
= Disabled
= Disabled
= Disabled
= Disabled
= 1
= 2
= 125
= 10000
= 1000
= 1,
= 90
= 30
Count Life
1 86
Count Life
1 250
March 2011
IPMS Application Example
page 20-37