Quick Steps For Creating A Virtual Router - Alcatel-Lucent OmniSwitch AOS Release 7 Manual

Configuring VRRP

Quick Steps for Creating a Virtual Router

1
Create a virtual router. Specify a virtual router ID (VRID) and a VLAN ID. For example:
-> vrrp 6 4
The VLAN must already be created on the switch. For information about creating VLANs, see
Chapter 4, "Configuring VLANs."
2
Configure an IP address for the virtual router.
-> vrrp 6 4 address 10.10.2.3
Note. IP can be used as an optional parameter instead of Address in the above example.
3
Repeat steps 1 through 2 on all of the physical switches that will participate in backing up the
address(es) associated with the virtual router.
4
Enable VRRP on each switch.
-> vrrp 6 4 enable
Note. Optional. To verify the VRRP configuration, enter the
to the one shown here:
VRRP trap generation: Enabled
VRRP startup delay: 45
IP
VRID VLAN Address(es)
----+-----+----------------+----------+----------+--------+---------
6 4 10.10.2.3
For more information about this display, see the OmniSwitch CLI Reference Guide.
OmniSwitch AOS Release 7 Network Configuration Guide
(expired)
Admin
Status Priority
Enabled 100
March 2011
Quick Steps for Creating a Virtual Router
show vrrp command.The display is similar
Adv
Preempt Interval
yes 1
page 18-5