Table of Contents
Advertisement
Configuring 802.1AB
-> lldp chassis tlv management port-description enable
To enable the management TLV on port 3 of slot 2, enter the following command at the CLI prompt:
-> lldp port 2/3 tlv management system-capabilities enable
To disable the management TLV on a switch, enter the lldp tlv management command:
-> lldp chassis tlv management port-description disable
To disable management TLV on port 3 of slot 2, enter the following command at the CLI prompt:
-> lldp port 2/3 tlv management system-capabilities disable
Enabling and Disabling 802.1 TLV
The
lldp tlv dot1
command is used to control per port 802.1 TLVs transmission in the LLDPDUs on a
specific port, a slot, or all ports on a switch. When enabled, the LLDPDU administrative status must be in
the transmit state.
To enable the 802.1 TLV LLDPDU transmission on a switch, enter the lldp tlv dot1 command:
-> lldp chassis tlv dot1 port-vlan enable
To enable the 802.1 TLV on port 1 of slot 5, enter the following command at the CLI prompt:
-> lldp port 5/1 tlv dot1 vlan-name enable
To disable the 802.1 TLV on a switch, enter the lldp tlv dot1 command:
-> lldp chassis tlv dot1 port-vlan disable
To disable 802.1 TLV on port 2 of slot 5, enter the following command at the CLI prompt:
-> lldp port 5/2 tlv dot1 vlan-name disable
Enabling and Disabling 802.3 TLV
The
lldp tlv dot3
command is used to control per port 802.3 TLVs transmission in the LLDPDUs on a
specific port, a slot, or all ports on a switch. When enabled, the LLDPDU administrative status must be in
the transmit state.
To enable the 802.3 TLV LLDPDU transmission on a switch, enter the lldp tlv dot3 command, as shown:
-> lldp chassis tlv dot3 mac-phy enable
To enable the 802.3 TLV on port 4 of slot 2, enter the following command at the CLI prompt:
-> lldp port 2/4 tlv dot3 mac-phy enable
To disable the 802.3 TLV on a switch, enter the lldp tlv dot3 command, as shown:
-> lldp chassis tlv dot3 mac-phy disable
To disable 802.3 TLV on port 5 of slot 3, enter the following command at the CLI prompt:
-> lldp port 3/5 tlv dot3 mac-phy disable
OmniSwitch AOS Release 7 Network Configuration Guide
March 2011
Configuring 802.1AB
page 10-11
Advertisement
Table of Contents
