Alcatel-Lucent OmniSwitch AOS Release 7 Manual page 584

Num. Standard Attribute
7 Framed-Protocol
8 Framed-IP-Address
9 Framed-IP-Netmask
10 Framed-Routing
11 Filter-Id
12 Framed-MTU
13 Framed-Compression
14 Login-IP-Host
15 Login-Service
16 Login-TCP-Port
17 Unassigned
18 Reply-Message
19 Callback-Number
20 Callback-Id
21 Unassigned
22 Frame-Route
23 Framed-IPX-Network
24 State
25 Class
26 Vendor-Specific
27 Session-Timeout
28 Idle-Timeout
29 Termination-Action
30 Called-Station-Id
31 Calling-Station-Id
32 NAS-Identifier
33 Proxy-State
34 Login-LAT-Service
35 Login-LAT-Node
36 Login-LAT-Group
37 Framed-AppleTalk-Link
38 Framed-AppleTalk-Network
39 Framed-AppleTalk-Zone
60 CHAP-Challenge
61 NAS-Port-Type
62 Port-Limit
63 Login-LAT-Port
page 238
Notes
Not supported. These attributes are used for dial-up sessions;
not applicable to the RADIUS client in the switch.
—
Multiple reply messages are supported, but the length of all
the reply messages returned in one access-accept or access-
reject packet cannot exceed 256 characters.
Not supported. These attributes are used for dial-up sessions;
not applicable to the RADIUS client in the switch.
Sent in challenge/response packets.
Used to pass information from the server to the client and
passed unchanged to the accounting server as part of the
accounting-request packet.
See "Vendor-Specific Attributes for RADIUS" on page
Not supported.
Not supported.
Not supported. These attributes are used for dial-up sessions;
not applicable to the RADIUS client in the switch.
OmniSwitch AOS Release 7 Network Configuration Guide
23-9.
March 2011