To Remove And Replace The Line Filter Assembly - Agilent Technologies 16800 Series Service Manual

To remove and replace the line filter assembly

16800 Series Portable Logic Analyzers Service Guide
Perform previous procedures:
• "To prepare the instrument for disassembly"
page 120.
• "To remove and replace the cover"
• "To remove and replace the front panel assembly"
page 129.
1 Disconnect the line filter assembly cables from the power
supplies. In order to press the release latches on the
lower cable connection, you may need to slide the tray
assembly part way out following the procedure
remove and replace the tray assembly"
Using a Torx T10 screwdriver, remove the 2 screws
2
securing the power socket to the frame and the 1 screw
to the ground wire.
Line filter
assembly
T-10 screws (2)
3 Reverse this procedure to replace the power line filter
assembly.
Replacing Assemblies
on
on page 122.
"To
on page 146
T-10 screw
Ground wire
6
on
149