Transfer Result Report; Id Reception (Closed Network); Jbig Reception; Auto Fax Reception Power-Up - Savin 1045 Facsimile Reference Manual

Reception Features
- Sending the Transfer Result -
- -
Report
This machine compares the fax
number of the Requesting Party with
the Requesting Party's number pro-
grammed in a Quick Dial or Speed Di-
al. If the lower five digits of the two
numbers match, it sends the Transfer
Result Report to the Requesting Party.
For example:
• Requesting
number:
001813-11112222
• Transfer Station's Quick Dial:
5
03-11112222

Transfer Result Report

This reports whether transmission to
the End Receivers was successful or
not.
Preparation
Program the requesting party fax
n u mber i n advanc e . ⇒ P.16 1
"Transfer Report"
When the Transfer Station has trans-
ferred the message to all End Receiv-
ers, it sends the Transfer Result
Report back to the Requesting Party.
The machine prints the report if it
cannot be sent back to the Requesting
Party. You must program the fax
number of the requesting party in a
Quick Dial in the Transfer Station.
Note
❒ By default, a portion of the original
image is printed on this report.
You can turn this off with the User
Parameters. ⇒ P.136 "Changing the
User Parameters"(Switch04, Bit7)
80
Party's own dial

ID Reception (Closed Network)

If you wish to limit reception of mes-
sages from those with machines of the
same make and with the same Polling
ID, contact your service representa-
tive to turn this feature on.
Note
❒ When you use this function, contact
your service representative for details.

JBIG Reception

Fax Function Upgrade Unit is required.
It allows you to receive messages sent
in the JBIG format.
Limitation
❒ If ECM is turned off, JBIG Recep-
tion is not available.
❒ This feature is not available with
G4 communication.
❒ When the optional Extra G3 Interface
Unit is installed, JBIG receptions of
"G3-2" and "G3-3" lines are standard.

Auto Fax Reception Power-up

This machine can be set to shut down au-
tomatically if nobody has used the it for
a while. In these situations, even though
the operation switch is off, the machine
can still receive incoming messages as
long as the Main Power switch is on.
Important
❒ Reception is not possible if both
the operation switch and Main
Power switch are turned off.
Note
❒ By default, messages are printed as
soon as they are received (Immedi-
ate Reception). To change this, see
P.136 "Changing the User Parame-
ters"(Switch14, Bit0)