Table of Contents
Advertisement
Stamp
Optional Document Feeder (ADF) is re-
quired.
When sending a fax message using
the Document Feeder (ADF), the ma-
chine can stamp a circle mark at the
bottom of the original. When sending
a double sided document, they are
marked at bottom of the front page
and top of the rear page. This stamp
indicates that the original has been
successfully stored in memory for
Memory Transmission, or that it has
been successfully sent for Immediate
Transmission.
Limitation
❒ Stamp only works when scanning
from the Document Feeder (ADF).
❒ You cannot turn the Stamp feature
on or off while a document is being
scanned.
❒ Do not open the document feeder
(ADF) while scanning the docu-
ment. A document jam could occur.
Note
❒ When the stamp starts getting light-
er, replace the cartridge. ⇒ P.179
"Replacing the Stamp Cartridge"
❒ If a page was not stamped even
though the Stamp feature is turned
on, you need to resend that page.
❒ By default, Stamp is turned off. If
you use this feature often, you can
adjust the "Gen. Settings/Adjust"
so that the home setting is on. In
this case, Stamp can easily be
turned off for any single transmis-
sion by pressing [Stamp].
A
Place your original and select any
scan settings you require.
B
Press [Sub TX Mode].
The Sub Transmission menu is
shown.
C
Press [Stamp].
Note
❒ To cancel using stamp, press
[Stamp] again.
D
Press [OK].
The [Stamp] key is highlighted.
E
Dial and press the{ { { { Start} } } } key.
Sub Transmission Mode
4
65
Advertisement
Table of Contents
