Automatic Redial; Batch Transmission; Ecm (Error Correction Mode); Broadcasting Sequence - Savin 1045 Facsimile Reference Manual

Automatic Redial

If a fax message could not be trans-
mitted because the line was busy or
an error occurred during transmis-
sion, redialing is done 4 times at 5
minutes intervals (these figures vary
according to which country you are
in).
If redialing fails after four redials, the
machine cancels the transmission and
prints the Transmission Result Report
or Communication Failure Report.

Batch Transmission

If you send a fax message by Memory
Transmission and there is another fax
message waiting in memory to be
sent to the same destination, that
message is sent along with your orig-
inal. Several fax messages can be sent
with a single call, thus eliminating the
need for several separate calls. This
helps save communication costs and
reduce transmission time.
Fax messages for which the transmis-
sion time has been set in advance are
sent by batch transmission when that
time is reached.
Note
❒ By default, Batch Transmission is
switched on. You can switch it on
or off with the User Parameters. ⇒
P.136 "Changing the User Parame-
ters"(Switch14, Bit2)
More Transmission Functions

ECM (Error Correction Mode)

This feature automatically sends data
that was not transmitted successfully
using a system that complies with in-
ternational standards.
ECM requires that the destination
machine has the same feature.
Note
❒ By default, ECM is switched on.
You can change this with the Key
Operator Settings. ⇒ P.135 "ECM"

Broadcasting Sequence

If you dial several destinations for the
same message (Broadcasting) the
messages are sent in the order in
which they were dialed. If the fax
message could not be transmitted, the
machine redials that destination after
the last destination specified for
Broadcasting. For example, if you
specify four destinations A through D
for broadcasting, and if the lines to
destinations A and C are busy, the
machine dials the destinations in the
following order: A, B, C, D, A, and C.
Checking the Transmission
Progress
To check which destinations the fax
message has been sent to so far, print
the TX file list.
4
71