Table of Contents
Advertisement
Transmission Features
Manual Dial
The external telephone or optional Handset is required.
Pick up the handset of the external
telephone and dial. When the line is
connected and you hear a high-
pitched tone, press the {Start} key to
send your fax message. If, on the oth-
er hand, you hear a voice at the other
end, continue your conversation as
you would normally over the tele-
phone.
4
Limitation
❒ Manual Dial does not work with
ISDN lines.
❒ This feature is not available for the
optional Extra G3 Interface Unit.
❒ The result of the transmission with
manual dial is not mentioned in
the Transmission Result Report
(Immediate Transmission).
❒ When the Economy Transmission
mode has just been changed to
night, there is no sounds for a peri-
od of 4 seconds (Max) when you
pick up the handset. You can oper-
ate the machine after hearing a
tone.
A
Place your original and select any
scan settings you require.
Reference
⇒ Chapter 2, "Setting Originals"
in the Basic Features manual
⇒ Chapter 2, "Scan Settings" in
the Basic Features manual
B
Pick up the external telephone.
You will hear a tone.
52
C
Dial.
The machine immediately dials the
destination.
If you make a mistake, replace the
external telephone and try again
from step B.
D
When the line is connected and
you hear a high-pitched tone,
press the { { { { Start} } } } key to send your
fax message.
Note
❒ If you hear a voice, notify the
destination that you want to
send a fax message (ask them to
switch to Facsimile mode).
E
Replace the handset of the exter-
nal telephone.
After transmission, the machine
will return to standby mode.
Advertisement
Table of Contents
