Table of Contents
Advertisement
Transmission Features
More Transmission Functions
If Memory Runs Out While
Storing an Original
If you run out of memory while stor-
ing an original (free space reaches
0%),
"Memory is full. Cannot
scan more. Transmission will be
stopped."
Press [Exit] to transmit the stored pag-
es only.
4
Note
❒ By default, successfully scanned
pages are sent. If you wish to
change this setting, please contact
your service representative.
Parallel Memory Transmission
This function dials while the original
is being scanned. Standard Memory
Transmission stores the original in
memory, then dials the destination.
Parallel Memory Transmission al-
l ow s y o u to q u ic k ly d et erm i n e
whether a connection was made. In
addition, this function scans the orig-
inal faster than Immediate Transmis-
sion and is useful when you are in a
hurry and need to use the original for
another purpose.
Note
❒ By default this feature is turned on,
You can change this with the User
Parameters. ⇒ P.136 "Changing the
User Parameters"(Switch07, Bit2)
Limitation
❒ Standard Memory Transmission is
used instead of Parallel Memory
Transmission in the following cases.
• When the line is busy and could
not be connected to
70
is displayed.
• With Send Later
• With Transfer Request
• When you store an original for
Memory Transmission while
another communication is in
progress
• When two or more destinations
are specified
• When you send only an Auto
Document
• When the original is set on the
exposure glass
• When
you
stored in the Document Server.
Checking the Transmission
Result
• Turn the Transmission Result Re-
port on if you want a report to be
printed after every successful
transmission. ⇒ Chapter 2, "Mem-
ory Transmission" in the Basic Fea-
tures manual
If you leave the Transmission Re-
sult Report off, the report will not
be printed after every transmis-
sion. However, should a transmis-
sion fail, a Communication Failure
Report will be printed instead.
• If you turn the Transmission Re-
sult Report (Memory Transmis-
sion) off, the Error Report will be
printed when the communication
on fails.
• You can also check the transmis-
sion result by examining the Jour-
nal.⇒ P.25 "Printing the Journal"
You can either print or scroll
through the Journal on the display.
⇒ P.27 "Checking the Transmission
Result (TX File Status)"
send
messages
Advertisement
Table of Contents
