Removing A Front-Mounted Switch From A Two-Post Rack; Attach An Esd-Preventive Wrist Strap To Your Wrist And Connect The Metal End To An Appropriate Ground Point On The Rack; Verify That The Power Supplies Have Been Removed From The Switch - Extreme Networks Summit X150 Series Hardware Installation Manual

6 Remove the rack-mounting screws and detach the rear mounting brackets from the rack post
(Figure 121).
Figure 121: Removing the Rear Mounting Brackets

Removing a Front-Mounted Switch from a Two-Post Rack

Removing a front-mounted Summit X480 switch from a rack requires two people to maneuver the
switch and disconnect the mounting hardware.
To remove a front-mounted switch:
1 Attach an ESD-preventive wrist strap to your wrist and connect the metal end to an appropriate
ground point on the rack.
2 Verify that all power supplies have been removed from the switch.
3 Support the switch while you remove the rack-mounting screws holding the front mounting brackets
in place against the rack post
4 Slide the switch out of the rack.
Summit Family Switches Hardware Installation Guide
SH_125
(Figure 122).
147