Rack-Mounting An Eps-500 Power Supply - Extreme Networks Summit X150 Series Hardware Installation Manual

NOTE
An AC power cord is not provided with the EPS-500 unit. See
information about selecting a power cord.

Rack-mounting an EPS-500 Power Supply

CAUTION
When installing an EPS-500 in a rack system, make sure that the air vents are not restricted. Allow for elevated
ambient operating temperatures when the unit is installed adjacent to other equipment. To avoid hazardous
conditions due to uneven mechanical loading, make sure that the equipment is mounted properly in the rack
system.
Do not use the rack-mount brackets to suspend the EPS-500 from under a table or desk, or to attach the unit to a
wall.
To rack-mount each EPS-500:
1 Place the EPS-500 upright on a stable surface, with the side you want to face to the front of the
switch toward you.
2 Remove the mounting bracket kit from the packaging.
3 Attach the mounting brackets as follows:
a Place a mounting bracket over the mounting holes on one side of the EPS-500 (see
b Insert the provided screws and fully tighten the screws using a screwdriver.
Figure 153: Attaching a Mounting Bracket
c Repeat steps a and
4 Slide the EPS-500 into a 19-inch rack and secure it using appropriate rack-mount screws.I
NOTE
Extreme Networks recommends that you position the EPS-500 so that the output connectors are on the same
side as the external connector on the connecting switch. If you position the EPS-500 with the connectors facing
in the opposite direction from the Summit switch connector, leave at least 1 u between the switch and the EPS-
500 through which to slide the power cords. Do not route the power cords around the equipment rack.
Summit Family Switches Hardware Installation Guide
b on the opposite side of the EPS-500.
"Selecting Power Supply Cords" on page 218
Collin's
ES4K026
XM_073
for
Figure 153).
181