Installing A Summit X480 Ac Psu - Extreme Networks Summit X150 Series Hardware Installation Manual

Installing a Summit X480 AC PSU

WARNING!
To prevent an electrical hazard, make sure that the AC power cord is not connected to the PSU before you install
the PSU in the power supply bay.
CAUTION
Make sure that the AC PSU circuit is not overloaded. Use proper over-current protection, such as a circuit-breaker,
to prevent over-current conditions.
To install a Summit X480 AC PSU:
1 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate
grounding point.
2 If necessary, remove a blank panel from the back of the Summit X480 series switch
Figure 108: Removing a Blank Panel
3 Verify that the PSU is right side up, with the latching tab at the left of the unit (see
4 Carefully slide the PSU all the way into the power supply bay (see
the latch snaps into place.
CAUTION
Do not slam the PSU into the switch.
Summit Family Switches Hardware Installation Guide
SH_137
Figure 106). Push the PSU in until
(Figure 108).
Figure 106).
135