Installing The Power Supply - Extreme Networks Summit X150 Series Hardware Installation Manual

Installing Summit Family Switches
Figure 135: Attaching Terminals to Cables

Installing the Power Supply

CAUTION
The handle on the Summit X650 DC PSU is not designed to be used to lift or carry the Summit X650 series switch.
To install a Summit X650 DC PSU:
1 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate
ground point on the rack.
2 If necessary, remove a blank panel from the back of the Summit X650 series switch
Figure 136: Removing a Blank Panel
3 Verify that the PSU is right side up (see
4 Carefully slide the PSU all the way into the power supply bay (see
the latch snaps into place.
CAUTION
Do not slam the PSU into the switch.
160
Power connection wire
SH_109
SH_106
Figure 137).
Summit Family Switches Hardware Installation Guide
Ground wire
(Figure
Figure 137). Push the PSU in until
SH_110
136).