Installing Summit X480 Power Supplies; Ac Power Supply Cords - Extreme Networks Summit X150 Series Hardware Installation Manual

Installing Summit Family Switches
Figure 107: Securing the Switch to the Front Rack Posts—Four-Post Installation
After the switch is secured to the rack, install and connect power supplies as described on
AC power supplies or on

Installing Summit X480 Power Supplies

The Summit X480 series switch is shipped without installed power supplies. The switch accommodates
one or two Summit X480 power supply units (PSUs).

AC Power Supply Cords

An AC power cord is not included with the Summit X480 AC PSU. AC power cords for use in the US
and Canada from Extreme Networks or from your local supplier. The cord must meet the following
requirements:
The power cord must be agency-certified for the country of use and rated for 100-240 V AC.
●
The power cord must have an IEC 320 C13 connector for connection to the PSU.
●
The power cord must have an appropriately rated and approved wall plug applicable to the country
●
of installation.
For cords up to 6 feet (2 m) long, the wire size must be 18 AWG (.75 mm
●
minimum wire size is 16 AWG (1.0 mm
For additional power cord requirements, see
134
page 136 for DC power supplies.
2
).
"Selecting Power Supply Cords" on page
SH_147
2
) minimum; over 6 feet, the
218.
Summit Family Switches Hardware Installation Guide
page 135 for